Which is better in NTTF, computer or tool and die making?

The courses offered at Nettur Technical Training Center (NTTF) differ from other institutes across India. However, in case you are looking for a broad spectrum of placement and standard quality of education, it is best that you find an institute that is rather situated in an industrial area, such as the one located in Bangalore.

1. If you are more inclined towards a mechanical-oriented course, then go for a Diploma in Tool and Die Making to secure a relevant job, preferably with a job experience to escalate to a good position later in life. 
2. However, because you will hold a diploma in the course, it might as well take some time to secure a good position in the mechanical field. One of the other courses offered at the institute is Mechatronics. 
3. On the other hand, the courses offered in the department of computers will possibly fetch you a job with minimal pay, at least until you secure a good position with a slight pay raise. 

It is best that you do not join NTTF because the course fee is almost the same as any private engineering college. It would be an extravagant expenditure.