Master of Technology [M.Tech] (Microelectronics and VLSI Design) From NIT Calicut, Calicut

I have a friend who recently graduated with M.Tech in VLSI Design from NIT Calicut. According to him, the placements are great. According to recent placement highlights, the average CTC offered at the institute is 11 LPA.

In order to secure decent placements, all you need is the following. 

• Knowledge of EDA tools of Mentor or Cadence or Synopsys.
• Be skilled in RTL, Verilog coding.
• Know basics of verification and design parameters for speed vs power vs area.

You also should have sound knowledge of Place and Route; extract parameters to compare or adjust design parameters with layout changes. The demand in this field is high. Work hard and you will succeed.

My brother goes to NIT Calicut so I can give you some insight into their M.Tech VLSI and EDT course. Here are the glimpses of the placement record for the year 2020.

• The placement percentage for the programs MTech Microelectronics and VLSI Design has been 100%. All the 12 registered students got placed.
• The placement percentage for the program MTech Electronics Design Technology has been 71.4%. 10 out of 14 registered candidates got placed.

The average CTC offered to both of these programs is almost similar. Also, the course has a good ROI. M.Tech Microelectronics and VLSI Design is in great demand and it is turning out to be one of the best courses at NIT Calicut.

The VLSI placement in NIT Calicut is average, with a slight low count in job offers, and a minimum of 50% internship offers. The table below gives a brief overview of M.Tech VLSI from NIT Calicut.

Key highlights:

• Previously, the department of VLSI allowed only 50% of students to go for internships. This rule was set up from the batch of 2018. Previously, 50% of the whole department was allowed for internships.
• Though the placement count is quite less, a good internship in companies like NVIDIA and Intel would result in a good pre-placement full-time offer.
• For the 2021 batch, the institute allowed all students for internships, because of problems with guiding students virtually in COVID circumstances. Even if this rule is evoked in the future, the minimum 50% internship rule will be available.

Therefore, the placement in VLSI at NIT Calicut is average, but with some good internship and full-time conversion offers.